the VTR SETUP menu item 101 “SELECTION FOR SEARCH DIAL ENABLE”.

5-4-3 Capstan Override Playback

When playing back the same program on two VTRs, you can adjust the playback phases of the two VTRs so that they are synchronized.

There are two ways to make this adjustment:

(A)Using the search dial

(B)Using the +/– buttons

Note

When using method (A), change the system setup so that jog/shuttle mode playback is inhibited even when the search dial is rotated. Doing so prevents the VTR from accidentally entering jog/shuttle mode during capstan override playback.

Set the VTR SETUP menu item 101 “SELECTION FOR SEARCH DIAL ENABLE” to “via search key”.

1(B)

1,2 1(A)

1 Use either method (A) or (B).

(A)Rotate the search dial while holding down the PLAY button to adjust the playback speed.

The adjustment range is ±15% (in steps of 1%) of the normal playback speed.

(B)Press the + or – button while holding down the PLAY button to adjust the playback speed. Every time the + or – button is pressed, the speed changes by 1 frame.

During playback at increased or decreased speed, the SERVO indicator goes off since the servo is not locked (capstan override).

2 Release the PLAY button after you have finished adjusting the phase.

The VTR returns to normal-speed playback and the SERVO indicator lights up.

5-4-4 DMC Playback

Overview of DMC playback

DMC (Dynamic Motion Control) playback allows you to vary the playback speed in variable mode (in the DT playback range from –1 to +2 times normal speed) for certain sections of the tape, then store the specified speed in memory for later playback.

For example, during a live broadcast of a sporting event, you can set the start and end points of important scenes while recording, and immediately play back and broadcast those scenes using DMC playback.

Storing playback speeds in memory

Follow the procedure below to store DMC playback speeds in memory.

5

12 3,7 4,6

1In the HOME menu, press the ALT/[F7] (DMC) buttons to light up DMC on the display.

2Set a start point during recording or on a previously recorded tape by simultaneously pressing the ENTRY button and the IN button.

3Press the STOP button to enter stop mode.

4Rotate the search dial to select the initial playback speed.

The selected speeds are shown in the time data display window in the menu display.

Note

If the VTR SETUP menu item 101 “SELECTION FOR SEARCH DIAL ENABLE” is set to “dial direct”, initial speed settings cannot be made. Change the setting of this menu item to “via search key”.

5 Press the PREROLL button and PREVIEW/REVIEW button simultaneously.

Recording/Playback 5 Chapter

5-4 Playback 111