Settings Menu 4 Chapter
State of the | IN point | OUT point |
data |
|
|
IN point data has not been | Data is not | Data is |
entered | updated | updated |
|
|
|
Updating File Name data
To update File Name data, press the cursor t button several times.
To update data
1 With the cursor buttons, align the cursor with the File Name data you want to update.
To move the cursor with the numeric buttons Enter a line number with the numeric buttons, and press the [F9] (CUENUM POINT) button. The cursor moves to the line number you entered.
2 Press the [F4] (CHANGE DATA) button.
3 With the cursor T or t button, select the character to be entered.
4 Press the [F7] (SET LETTER) button or cursor center button.
The selected character is entered.
5 Repeat steps 3 and 4, to enter the data.
A maximum of 15 characters can be entered.
Note
If the number of entered characters is too large, a memory overflow may occur, and it may become impossible to enter other cue point data. Press the [F8] (TAPE INFO) button to check the free memory capacity.
To enter a space
Press the [F5] (SPACE) button, then carry out entry.
If you make an error in entry
Press the [F6] (BACK SPACE) button, then carry out entry.
Canceling and repeating the process
Press the [F9] (CANCEL) button, then carry out entry.
To change a character during the operation
Press the cursor R button, then move the cursor to the comment frame. With the cursor T button or t button, change the character insertion position.
6 Press the [F10] (SAVE/EXIT) button.
This returns to the original menu screen.
Cueing up to the IN point
1 Hold down the [F1] (CUE SCAN) button, and press the PREROLL button. This sets the cursor movement direction.
Each press cycles through the settings FWD/REW/No setting.
FWD: Pressing the PREROLL button moves the cursor to the next line, and cues up to the time data of that line. Invalid time data is ignored.
REW: Pressing the PREROLL button moves the cursor to the previous line, and cues up to the time data of that line. Invalid time data is ignored.
2 Press the PREROLL button.
To
To
Canceling the
To cancel the
To insert a new line
1 Use the cursor buttons to position the cursor (B) below the line where a new line will be inserted.
To move the cursor with the numeric buttons To move the cursor, enter a line number with the numeric buttons, then press the [F9] (CUENUM POINT) button. The cursor moves to the line number you entered.
Note
If the cursor buttons are not linked to movement of the entry cursor B, it is not possible to move the entry cursor B with the cursor buttons.
To link the cursor buttons to movement of the entry cursor B
Press the cursor center button. To unlink, press the cursor center button once again.
2 Press the ENTRY button while pressing down the SFT button.
A new line is inserted above the line specified by where the cursor (B) is placed and the current time data is entered on that line.
76