Sony To change the insert end point, Inserting a scene from a VCR – Insert Editing

Inserting a scene from a VCR – Insert Editing

(1) Set the POWER switch to VCR on your camcorder.

(2) On the connected VCR, locate just before the insert start point [a], then press X to set the VCR to the playback pause mode.

(3) On your camcorder, locate the insert end point [c] by pressing mor M. Then press Xto set your camcorder to the playback pause mode.

(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY indicator flashes and the end point of the insert is stored in memory. The tape counter shows “0:00:00.”

(5) On your camcorder, locate the insert start point [b] by pressing m. Press

zREC and the button on its right simultaneously, then immediately press X to set your camcorder to the recording pause mode.

(6) First press Xon the VCR, and after a few seconds press Xon your camcorder to start inserting the new scene.

Inserting automatically stops near the zero point on the counter. Your camcorder automatically stops. The end point [c] of the insert stored in memory is canceled.

5

PAUSE REC

4 ZERO SET	0:00:00
	ZERO SET
MEMORY
	MEMORY

To change the insert end point

Press ZERO SET MEMORY again after step (5) to make the ZERO SET MEMORY indicator disappear and begin from step (3).

124