Connections and Preparations

This section describes how to install the projector and screen, how to connect the equipment from which you want to project the picture, etc.

Unpacking

Check the carton to make sure it contains the following items:

•Remote control (1) and Size AA (R6) batteries (2)

•AC power cord (1)

•Lens cap (1)

When you have purchased the projector, the lens cap was fitted onto the lens. Remove this lens cap when you use the projector.

•Signal cable (HD D-sub 15-pin y 3 × phono plug) (1)

(9-885-125-47, SONY)

•Operating Instructions (this manual)

•Warranty card (1)

Inserting the batteries into the remote control

Push and slide to open.

Insert the batteries E side first as shown in the illustration. Inserting them forcibly or with the polarities reversed may cause a short circuit and may generate heat.

Caution about handling the remote control

•Handle the remote control with care. Do not drop or step on it, or spill liquid of any kind onto it.

•Do not place the remote control in a location near a heat source, a place subject to direct sunlight, or a damp room.

12