The ?/1 (On/standby) switch flashes in green, then lights in green.

The projector cannot be used while the ?/1 switch is flashing.

3Turn on the equipment connected to the projector.

Refer to the operating instructions of the connected equipment.

4Press INPUT repeatedly to select the input you want to project on the screen.

Each time you press the button, you can select the input in the following sequence.

Input-A t HDMI t Video t S-Video

To view the picture from

Press INPUT

 

to display

 

 

Computer/Component

Input-A

connected to the INPUT

 

A connector

 

 

 

Computer/VCR, etc.

HDMI

connected to HDMI

 

(digital) connector

 

 

 

Video equipment

Video

connected to the VIDEO

 

INPUT connector

 

 

 

Video equipment

S-Video

connected to the

 

S VIDEO INPUT

 

connector

 

 

 

Notes

•If “Auto Input Search” is set to “On,” the projector searches for the signals from the connected equipment and displays the input channel where the input signals are found. (1 page 39)

•When the analog signal is input from a computer, the Smart APA (Auto Pixel Alignment) feature adjusts the picture of the connected equipment to its clearest.

•Depending on the type of your computer, for example a notebook, or an all-in-one LCD type, you may have to switch the computer to output to the projector by

pressing certain keys (e.g.,

LCD / VGA , / , etc.), or by

changing your computer’s settings. The key used for switching the computer to output to the projector varies depending on the type of computer

F7 or Fx

and

Fn

Turning Off the Power

1Press the ?/1 switch.

A message “POWER OFF? Please press ?/1 switch again.” appears on the screen.

Note

The message disappears if you press any button other than the ?/1 switch, or if you do not press any button for five seconds.

2Press the ?/1 switch again.

The ?/1 switch flashes in green and the fan continues to run to reduce internal heat. Also, the ?/1 switch flashes quickly for the first 60 seconds. During this time, you will not be able to light up the ?/1 switch again with this switch.

3Unplug the AC power cord from the wall outlet after the fan stops running and the ?/1 switch lights in red.

Projecting

27