Manuals / Brands / Computer Equipment / Projector / Sony / Computer Equipment / Projector

Sony VPL-BW5 Projecting, Projecting the Picture on the Screen, 1,2

1 64

Download 64 pages, 3.51 Mb

Projecting

This section describes how to operate the projector to view the picture from the equipment connected to the projector. It also describes how to adjust the quality of the picture to suit your taste.

Projecting the Picture on the Screen

1,2 4

Rear remote control detector

1After connecting the AC cord to the projector, plug the AC cord into a wall outlet, connect all equipment, and remove the lens cover.

The ?/1 (On/standby) switch lights in red and the projector goes into standby mode.

2Press the ?/1 (On/standby) switch to turn on the projector.

Contents

VPL-BW5 WARNING Disposal of the used lamp Für Kunden in Deutschland For the customers in Taiwan only Table of Contents Location of Controls Connections and Preparations Projecting Precautions Location of Controls Top/Front/Side aVentilation holes (exhaust) bLens cFront remote control detector d?/1 (On/standby) switch eINPUT button Rear/Bottom aVentilation holes (intake)/Air filter cover bAdjusters (fore pad) cLamp cover dAdjuster eS VIDEO INPUT connector (mini DIN 4-pin) Remote Control aLIGHT button bINPUT button cFREEZE key dM/m/</, (arrow)/ (enter) buttons eMENU button Connections and Preparations Unpacking Step 1: Installing the Projector Before Setting Up the Projector Very dusty and extremely smoky Do not block the ventilation holes locations Unsuitable conditions Do not use the projector under the following conditions Page Positioning the Projector and a Screen 2 Position the projector so that the lens is parallel to the screen Top view Step 2: Connecting the Projector Connecting to a VCR Page To connect to a VCR equipped with the S video connector or video connector Connecting to a Computer Step 3: Adjusting the Picture Position 5Adjust the upper or lower position of the picture Using the adjuster 7Adjust the picture size using the zoom lever 8Adjust the focus using the focus ring 6Adjust the trapezoidal distortion of the picture Step 4: Selecting the Menu Language Page Projecting Projecting the Picture on the Screen Turning Off the Power Selecting the Wide Screen Mode Zoom (When the SD or PC signal is input) Full 1 (When the PC signal is input) Full 2 (When the PC signal is input) Selecting the Picture Viewing Mode Adjusting the Picture Quality Using Other Functions Using the Menus Operation through the Menus 4 Make the setting or adjustment of an item Items that cannot be adjusted To clear the menu To reset the items that have been adjusted Items that can be reset are: PICTURE SETTING Menu Page INPUT SETTING Menu About the Preset Memory No SET SETTING Menu Page MENU SETTING Menu INSTALL SETTING Menu Page INFORMATION Menu Input Signals and Adjustable/Setting Items Others Troubleshooting Power Picture Remote control Indicators Message Lists Warning Message Caution Message Replacing the Lamp 6Close the lamp cover and tighten the screw 7Turn the projector back over 8Connect the power cord 9Press the ?/1 switch to turn the projector on switch Cleaning the Air Filter Specifications Optional accessory Pin assignment INPUT A connector (HD D-sub 15-pin,female) Preset Signals Page Installation Diagram Floor Installation (Front Projection) PS: Ceiling Installation (Front Projection) Page Dimensions Top Index