Notes

•When connecting equipment to the HDMI input of the projector, be sure to use equipment that have acquired the HDMI logo.

•When connecting an HDMI cable to the projector, make sure the v mark on the lower part of the HDMI input of the projector and the v mark on the connector of the cable is set at the same position.

•If the picture from equipment connected to the projector with an HDMI cable is not clear, check the settings of the connected equipment.

•The HDMI connector of this projector is not compatible with DSD (Direct Stream Digital) Signal or CEC (Consumer Electronics control) Signal.

To connect to a DVD player/recorder, Blu-ray Disc player or digital tuner equipped with a video GBR/component video connectors

Preparations and Connections

Rear of the projector

S VIDEO VIDEO

INPUT A

 

INPUT

Speakers

AV amplifier

DVD player/recorder, HDD recorder, Blu-ray Disc player, digital tuner, etc., with video GBR/component video connectors

to video GBR or component output

Signal cable (HD D-sub 15-pin (male) y 3 × phono plug) (supplid)

:Video signal flow

•Set the aspect ratio by pressing WIDE MODE on the remote control or using “Wide Mode” in the INPUT SETTING menu according to the input signal.

•When you connect the projector to a video GBR output connector, select “Video GBR” or when you connect the projector to component output connectors, select “Component” with the “Input-A Signal Sel.” setting in the SET SETTING menu.

19