Signal Menu

The Signal menu is used to adjust the input signal. You can adjust the size of the picture, and select wide screen mode, etc.

.

Adjust Signal menu

Picture

Adjust Signal

 

Dot Phase :

24

 

Signal

H Size :

1344

Shift :

H:204 V:34

 

Function

Installation

Setup

Information

Sel: Set: Back: Exit:

Adjust Signal

You can adjust the input signal.

Dot Phase

Adjusts the dot phase of the panel and the computer signal.

 

Adjust the picture to the point where it looks clearest.

 

 

H Size

Adjusts the horizontal size of the picture from a computer.

 

The higher the setting, the wider the picture. The lower the setting,

 

the narrower the picture.

 

Adjust the setting to match the number of dots of the input signal.

 

 

Shift

Adjusts the position of the picture.

 

H: As the setting for H (horizontal) increases, the picture moves to

 

the right, and as the setting decreases, the picture moves to the left.

 

Use < or , to adjust the horizontal position.

 

V: As the setting for V (vertical) increases, the picture moves up,

 

and as the setting decreases, the picture moves down. Use M or m to

 

adjust the vertical position.

 

 

Wide Mode

You can set the aspect ratio of the picture to be displayed for the current input signal. This item is enabled only when an SD signal (preset memory numbers 1 to 6) is input.

Full

A picture squeezed to 4:3 is displayed with the correct aspect.

 

 

Normal

A 4:3 aspect ratio picture is displayed to fill the vertical screen

 

height.

 

 

Wide Zoom

A 4:3 aspect ratio picture is enlarged and the upper and lower

 

portions are compressed to fit the 16:9 screen.

 

 

Zoom

A 4:3 aspect ratio picture is enlarged vertically and horizontally

 

at the appropriate ratio to fill the 16:9 screen.

 

 

Subtitle

The subtitle area is compressed and displayed at the lower part

 

of the screen.

 

 

Menus the Using

Signal Menu 47 GB