Please replace the Lamp/

c It is time to replace the lamp. Replace the lamp. (1 page 63)

Filter.

c Also, replace the air filter too. (1 page 67)

End of Lamp/Filter life.

If this message appears again after you replace the lamp and filter,

Lamp off in 1 min.

the lamp replacement process is not complete. Check the lamp

 

replacement process. (1 page 63)

 

 

Please clean the filter.

c It is time to clean the air filter. Clean the air filter. (1 page 66)

 

 

Please clean the filter. Have

c It is time to clean the air filter. Clean the air filter. (1 page 66)

you finished? Yes V No v

c If you cleaned the air filter, select “Yes.” If you did not clean the

 

air filter, select “No.”

 

 

Probably use in high

c When using the projector at an altitude of 1,500 m or higher:

altitude. Switch to high

select “Yes” to set to “High Altitude Mode”. (1 page 52)

altitude mode on? Yes V

c If this message is displayed when using the projector at an

No v

altitude of less than 1,500 m: check to see if nothing is blocking

 

the ventilation holes. (1 page 14)

 

Note

 

When you selected “Yes,” the number of turns of the fan increases.

 

 

Caution messages

Message

Cause and Remedy

 

 

x

c No signal is input in the selected input. Check connections. (1

 

page 18)

 

 

Not applicable!

c Press the appropriate button.

 

 

Please check Network

c Invalid values, such as a blank, are entered in the

Setting.

Network Setting window. Enter the correct values. (1 page 52)

 

 

GB 62 Troubleshooting