For Machines Mfg. Since 8/11 | P R E P A R A T I O N | Model SB1001 8K™ Lathe |
Test Run
After all preparation steps have been completed, the machine and its safety features must be tested to ensure correct operation. If you discover a problem with the operation of the machine or its safety components, stop the motor, disconnect the machine from power, and do not operate it further until you have resolved the problem.
A Troubleshooting section is provided, starting on Page 57, to assist you with solutions if a problem occurs or if the lathe does not function as described in this section.
If you need additional help after reviewing the troubleshooting section, or you are not confident troubleshooting the machine on your own, contact our Tech Support at (360)
To test run your machine:
1.Make sure the master power switch
(see Figure 14) on the front of the machine is turned OFF.
Master
Power
Switch
3.Clear away all tools and objects used during assembly, lubrication, and preparation.
4.Make sure that the chuck and jaws, if installed, are secure (refer to Chuck Installation on Page 25).
Note: If a chuck is not installed on the lathe, you do not need to install one for this test.
5.Push the emergency STOP button on the control panel (see Figure 15).
Emergency | Tachometer |
STOP | Display |
Button |
|
Spindle
SpindleSwitch
Speed
Dial
Figure 15. Control panel.
6.Turn the spindle speed dial all the way counterclockwise to set the spindle to its slowest speed for
7.Move the spindle switch to the OFF (middle) position.
8.Make sure the end cover is closed, as shown in Figure 16.
Figure 14. Master power switch location.
2.Read and follow the safety instructions at the beginning of the manual, take all required safety precautions, and make sure all previous preparation steps discussed in this manual have been followed and completed.
End
Cover
