Southbend SB1001 owner manual Grease Fittings, Longitudinal Leadscrew

For Machines Mfg. Since 8/11 S E R V I C E Model SB1001 8K™ Lathe

Grease Fittings

Grease Type	NLGI#2
Lubricating Device	Included Grease Gun
Amount	1–2 Pumps
Frequency	Daily

The exact amount may vary slightly for each fitting on the machine. If excessive grease is seen exiting between the parts, reduce the amount added.

There are 10 grease fittings on the Model SB1001 that require daily lubrication with the included grease gun. Refer to Figures 82–85for the locations of these fittings.

3

Fittings

Figure 82. Five grease fittings inside end cover.

Leadscrew

Fitting

Figure 83. Left leadscrew bushing grease fittings.

3

Fittings

Figure 84. Carriage grease fittings.

Tailstock

Fittings

Leadscrew

Fitting

Figure 85. Tailstock and right leadscrew bushing

grease fittings.

Longitudinal Leadscrew

Oil Type	Mobil Vactra 2 or ISO 65 Equivalent
Amount	As Needed
Frequency	Daily

Before lubricating the leadscrew, clean it first with mineral spirits and a stiff brush. Make sure to move the carriage so that you clean the entire length of the leadscrew.

Apply a thin coat of oil along the length of the leadscrew. Use a clean stiff brush to make sure the oil is applied evenly and down into the threads.

Note: In some environments, abrasive material can become caught in the leadscrew lubricant and drawn into the half nut. In this case, lubricate the leadscrew with a quality dry lubricant.

-51-