Speco Technologies 16TH, 8TH, 4TH Client IP, Dial-in Idle Time, Dial-in Max Time, Dial-out Setup

User’s Manual

Client IP

This item determines the remote PC’s IP address for connecting with the DVR-4TH/ 8TH/ 16TH series unit. To set the Client IP, follow these steps:

•Select <Client IP> and use LEFT/ RIGHT to move the cursor over the IP, and stop where you want to make the change.

•Press ENTER, then use UP/ DOWN to change the value.

•When done, press ENTER again to exit.

•Repeat the procedure until the IP is set completely.

Dial-in Idle Time

This item indicates the longest amount of time that the modem connection remains active if there is no acknowledgement from the remote pc. The value can be set from 0 min to 600 min.

Dial-in Max Time

The item indicates the longest amount of time that the connection via modem remains active. The value can be set from 0 min to 600 min.

Dial-out Setup

The Dial-out function enables the user to establish dial-up modem communication to and from the DVR-4TH/ 8TH/ 16TH series unit for remote notification use. The user can connect one modem to the DVR-4TH/ 8TH/ 16TH series unit. For more information for dial-up setting on PC, see appendix Dial-up Connections via Modem.

NOTE: The Dial-out Service is not available if there is no modem connected to the unit.

In the Network Setup menu, select <Dial-out Setup> and press ENTER to enter the Dial-out menu. The menu displays as follows.

	Dial-out Setup
Dial-out DHCP			OFF
Dial-out IP	0.	0.	0.	0
Dial-out Netmask	0.	0.	0.	0
Dial-out Gateway	0.	0.	0.	0
Dial-out DNS	0.	0.	0.	0
Phone Number
Dial-out Account
Dial-out Password			0 Min
Dial-out Idle Time
Dial-out Max Time			0 Min
Connect				No

76	DVR-4TH/8TH/16TH Series
	SPECO TECHNOLOGIES 07/10