SSI America 7SL instruction manual Specifications

SPECIFICATIONS

Case	RABS Grey dark color (RAL 7043).
	Self-extinguishing degree V0
	according to UL 94
Front panel	Designed and tested for IP65 and NEMA
	4X for indoor location (when panel gasket
	is installed). Tests were performed in
	accordance with IEC 529, CEI 70-1 and
	NEMA 250-1991 STD.
Installation	Panel mounting
Rear Terminal Block
	15 screw terminals with safety rear cover
Dimensions	Unit with RS-485 communications
	DIN 43700 48 x 48 mm x 122 mm
	(1.890 x 1.890 in. x 4.803 in).
Dimensions	Unit without RS-485 communications
	DIN 43700 48 x 48 mm x 105 mm
	(1.890 x 1.890 in. x 4.134 in).
Cutout	45 x 45 mm (1.772 x 1.772 in).
Weight	250 g (8.75 oz).
Upper Display		4 digits, 7 segment red LED’s with
	decimal point, 7.62 mm high (0.3 in).
Lower Display		2 digits, 7 segment red LED’s with
	decimal point, 7.62 mm high (0.3 in).
Indicator	2 red LED annunciators for:
	“RESET” Indicates control output status
	as follows:
	a)	With configuration parameter
		C2 = 0
		LED ON when Output is OFF
		LED OFF when Output is ON
	b)	With configuration parameter
		C2 = 1

LED flashes when Output is OFF LED ON when Output is OFF and acknowledged

LED OFF when Output is ON

“ALM” indicates alarm status as follows: Flashes when alarm is ON.

ON when alarm has been acknowledged

OFF when alarm is OFF RMT A decimal point on the right side

of the upper display flashes to indicate the device is controlled by serial link

Keyboard Four keys (covered by polyester mem- brane) labelled RESET, , & FUNC.

Power Supply 100 to 240 Vac 50/60 Hz switching or 24 Vac/Vdc with interruptions less than

100ms

Power Supply Variation

-15% to 10% (for 100 to 240 Vac) -10% to 10% (for 24 Vac/Vdc)

Power Consumption 8 VA max Insulation Resistance Greater than 100 MΩ Insulation Strength1500 V rms for 1 minute

EC Compatibility

Conforms with 89/336/EEC directives re- garding electro-magnetic compatibility Emission Complies with:

Generic emission standard EN50081-2 Immunity Complies with the generic im- munity standard EN50082-2. Conforms with 72/23/EEC and 93/68/EEC directives regarding low voltage. It complies with the safety requirements for electrical equip- ment for measurement, control and laboratory use, Generic Standard EN61010-1, Installation Category II.

Sampling

Time	250 ms for linear input
	500 ms for TC/RTD input

2 6

7sl-5-00.p65 26 9/17/02, 2:43 PM