Federal Communications Commission
Radio Frequency Interference Statement
‘his equipment generates and uses radio frequency energy and if not installed and used properly. that
is, in strict accordance with the manufacturer’s instructions, may cause interference to radio and
is no guarantee that interfemnce wilJ not occur in a particular instaUation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followmg measures:
•Reorient the receiving antenna
•Relocate the computerorprinterwithrespectto the mceiver
•Move the computer or printer away from the receiver
•Plug the computer or printer into a different outlet so that it and the receiver ate on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. ‘Ibe user may find the following
ticns caMlis sion helpful: “How to Identity and Resolve Ra
Wet is available from the U.S. Government printing office. Washington, D.C.. 20402, Stock No.
For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.
The above statement applies only to printers marketed in the USA.
Statement of
The Canadian Department of Communications
Radio Interference Regulations
Ibis digital a aratus does not exceed the Class B limits for radio noise emissions from digital apparatus
setoutinthe%a dto Interference Regulations of the Canadian Department of Communications.
Lz pr&sent appareiI numCrique n’6met pas de bruits radioelecttiques d6passant les limites applicables aux
aIpate.ils numCri ues de la classe B prescrites dam le Reglement sur le brouillage radiotlectrique edict6
par le minisdm 1 es Communications du Canada.
The above statement applies only to printers marketed in CaMda.
Trademark Acknowledgements
IBM PC, Proprinter X24, Proprinter II,
Microsoft BASIC,
NOTICE
•All rights reserved. Reproduction of any part of this manual in any form whatsoever without
STAR’s express gxmission is forbidden.
• lltecontentsof | s manual are SubJect to change without notice. |
•Ail efforts have been made to ensure the accuracy of the contents of this manual at the time of press. However, should any errors be detected, STAR would greatly appreciate being informed of them.
•‘Ihe above notwithstanding, STAR can assume no responsibility for any errors in this manual.
0 Copyright 1989 Star Micronics Co., Ltd.
