Star Micronics NX-2410 user manual Character SET Commands

CHARACTER SET COMMANDS

Select standard character set

pi

Selects the standard character set. This is the power-up default in Standard mode if DIP switch l-7 is ON.

Select IBM character set

~~

Selects an IBM character set. This is the power-up default in IBM mode if DIP switch 1-7 is OFF.

Select character set ##7

Mode	ASCII				Decimal			Hexadecimal
Both	<ESC>	“7”		27	55		IB	37
	Selects	character	set	#l.
Select	character set #2
Mode	ASCII				Decimal			Hexadecimal
Both	<ESC>	“6”		27	54		1B	36
	Selects	character	set	#2.
Select	international		character set
Mode	ASCli				Decimal			Hexadecimal
Std.	<ESC>	“R”	n	27	82	n	1B	52	n
IBM	<FS>	“R”	n	28	82	n	IC	52	n

Selects an international character set according to the value of n as shown next.

61