Sterling sse manual Mounting on the processing machine, Mounting onto a machine hopper

Machine-Side Hopper Loaders

4.4.1. Mounting on the processing machine

A VT Series adapter is required to mount the loader on the processing machine. Two-liter models require a VT 1.0 adapter. Five-liter models require a VT 2.3/70 or VT 2.8/70 adapter. Use the following procedure to mount the loader to the processing machine:

1.	Mount the VT Series adapter onto the flange
	of the processing machine.	Figure 5: VT Adapter
2.	Mount the loader onto the adapter.

FObserve the bearing capacity of the machine flange.

4.4.2. Mounting onto a machine hopper

Two-liter models require an EF 190 welding flange for mounting onto a machine hopper. Five-liter models can be mounted to a machine hopper using either the EF 253 welding flange or the MF 253 assembly flange.

Using the EF Series Welding Flange:

LPlease observe all safety regulations for the operation of welding equipments.

Always wear safety goggles.

Figure 6: EF Welding Flange

1.Weld the welding flange into the machine hopper lid.

2.Mount the loader onto the welding flange.

Using the MF Series Assembly Flange (Five liter models only)

1.	Mount the assembly flange into the machine hopper lid.
2.	Mount the loader onto the assembly flange.
		Figure 7: MF Assembly Flange

4-6 Assembly instructions