Page 27 of 60
Touching RESET TO DEFAULTS in the lower right of the
screen changes all the settings for this station back to
their factory defaults.
See pp. 46–49 for details on the options and their default
settings.
5. As appropriate, setup the rest of the stations using either
of the following methods:
• Use the PREVIOUS or NEXT buttons to navigate to
other stations. Touch PREVIOUS to go to the
previous “Station Setup” screen, or touch NEXT to
go to the next “Station Setup” screen.
5-2-3 Setting Up Pumps
Before starting the system, you must define several settings
for each pump, such as how quickly to shut it down when it
is not in use. This section first discusses how to use the
controller’s menu system to configure pumps. The table on
page 49 discusses the individual choices.
5-2-3-1 Setting Up a Single Pump
1. Go to the “Pump Status“ screen if needed. To reach this
screen from any other screen, touch PUMP STATUS
button. The “Pump Status” screen appears:
Figure 8: 6” “Pump Status” Screen
2. Touch the icon for the pump you want to set up, and hold
it for several seconds. The “Pump Setup” screen opens.