Page 31 of 60
To change the duration of the password, complete the
following steps:
1. On the “System Setup” screen (Figure 4), touch the
Operator Password Duration button or the Setup
Password Duration button, depending on which
password duration you want to change. A keypad pops
up.
2. Enter the number of minutes (between 1 and 99) that you
want to set as the password duration. Use CLR to erase
any mistakes. Use ENT to enter the value. The keypad
disappears, and the “System Setup” screen shows the
new setting.
5-2-5 Starting the System for the First Time
Once you have finished all the setup described above, you
are ready to start the system. To start your system, complete
the following steps.
1. At any screen, touch STATION STATUS or PUMP
STATUS on the bottom left side of the station status or
pump status screen.
2. For each station that you want to use, briefly touch its
icon. The icon turns green, indicating that the station is
full, or the icon turns yellow, indicating that the station
needs material.
3. Touch PUMPS STATUS. The “Pump Status “screen
opens (Figure 8)
4. For each pump that you want to use, briefly touch its
icon. The icon turns green, indicating that the pump is
ready.
5. Touch START SYSTEM in the lower left-hand corner of
the screen.
6. The system starts. If any alarm messages appear on the
screen, see p. 50.