Page 29 of 60
5-2-4 Finishing Setup: Setting Up Passwords
You can set up passwords for two levels of security: for
operators and for setup personnel. The controller comes
from the factory with neither password set. This allows every
user access to all functions.
5-2-4-1 Setup Password
If you define a password for setup personnel, then all
settings can be changed only after entering the password.
The password will be required to display the following
screens:
• System Setup (to review and change system-wide
settings).
• Station Setup (to review and change settings for all station
options).
• Pump Setup (to review and change settings for all pump
options).
5-2-4-2 Operator Password
If you define a password for operators, then a password will
be required to carry out any function (other than reviewing
station and pump status, silencing alarms, reviewing the
alarm log, and looking at help screens). Entering the
operator’s password will give the user access to the
functions at the following screens:
• Station Status (to enable or disable a station, and start or
stop system)
• Pump Status (to enable or disable a pump, and start or
stop system)
• Station Operator (to adjust a station’s convey time and
dump delay, activate priority convey, and review the
station’s last convey time and pump assignment;
depending on the options installed, the screen may also
enable the operator to adjust the purge time.
Entering the setup password will give the user access to all
functions.