Page 41 of 60
controller finishes the current convey, if any, and
resumes normal operation.
5-3-3 Advanced Tasks
This section describes the procedures carried out during
operation that are normally reserved for setup personnel.
These procedures require use of the setup password (if your
facility has defined one). The procedure for logging on and
off with the setup password is the same as for logging on
with the operator password; see p. 35 for step-by-step
instructions for logging on and off.
5-3-3-1 Reviewing and Resetting a Pump Hour Meter
The controller keeps two meters for the length of time a
pump has run. One, like a car’s odometer, keeps a running
total and cannot be reset. The other, like a car’s trip
odometer, counts the running time since the last reset.
To review and reset the hour meter, complete the following
steps:
1. At any screen, touch the PUMP STATUS button.
2. Touch and hold the icon for the pump. The “Pump Setup”
screen opens.
Figure 14: 6” Pump Setup Screen
The box labeled x Hours shows the running time since the
last reset. The box labeled total x Hours shows total
running time.
To reset the resettable meter, touch Hour Meter Reset. The
time above x Hours changes to 0.