Page 44 of 60
system begins using the pump. In addition, all “Station
Operator” and “Station Setup” screens show the new
pump assignment.
Standby Pump Errors
If the error message tells you to disable the source pump
and/or the standby pump, touch RETURN at this screen,
then PUMP STATUS at the “Pump Setup” screen. Take the
pumps offline and then return to the “Transfer to Standby
Pump” screen.
If the error message tells you that the standby pump has
stations assigned, you must either use a different standby
pump or you must remove the pump assignment for all
stations assigned to the standby pump. To remove the
assignments, complete the following steps:
1. Touch RETURN at the “Standby Pump” screen, and then
touch STATION STATUS.
2. Touch and hold a station icon to get to the “Station
Operator” screen.
3. Then touch STATION SETUP to go to the “Station
Setup” screen.
4. Use PREVIOUS and NEXT to review all pump
assignments.
5. Where necessary, choose ASSIGNED TO PUMP to set
station assignments to 0 (unassigned). Then return to the
“Transfer to Standby Pump” screen.
6. Touch left side pump value and enter the number of the
pump whose hoppers are to be transferred.
7. Touch right side pump value and enter destination pump
number.
Filter cleaning
Sterling pumps have two options available for filter cleaning;
these are vacuum pulse or compressed air filter cleaning.
Touching the ENABLE/DISABLE button located in the lower
left hand corner of the pump setup screen will allow the
operator to turn on/off these two options or disable the filter
cleaning option altogether.
Note: Each type of filter cleaning requires optional equipment that
must be purchased and installed prior to enabling this option.