MODELS 424 A N D 424FS I N S TA L L AT I O N
H I N G E A D J U S T M E N TM O D E L S
424 424FS
IMPORTANT NOTE: Install screws in all the mounting holes in the door frame. The nature of the door panel with a narrow outer rim and no connecting center member requires the support provided by the glass door.
After the door panel installation is complete, apply the cover patches or plugs provided over the holes on the inside surface of the door.
The cover patches or plugs are part of the insulation system on the door of the Wine Storage unit. Be sure to cover all the holes in the door that were used.
O V E R L AY S O L I D D O O R – M O D E L 4 2 4
IMPORTANT NOTE: The solid door panel for the Model 424 must be a minimum of 5/8" (16) thick and cannot exceed 20 lbs (9 kg).
Installation of the solid door panel is the same as the door panel for a glass door model.
A solid panel must not be installed on a glass door unit, as this may cause moisture to form behind the panel.
IMPORTANT NOTE: The Wine Storage unit must be installed and leveled before door hinge adjustments can be made.
The top and bottom cabinet hinges on Models 424 and 424FS are held in place with three permanent adjustment screws and two shipping screws. Refer to illustrations 11 and 12 below. The shipping screws must be removed and discarded to adjust the door alignment and fit. If no adjustments are neces- sary, it is recommended that all five screws remain in place.
On the Model 424FS, only the bottom door hinge can be adjusted. Remove and discard the two shipping screws and loosen the three hinge screws to adjust the door. Refer to illustration 12.
COMPLETING T H E I N S TA L L AT I O N
IMPORTANT NOTE: When you have completed the installation of the Model 424 or 424FS Wine Storage unit, refer to pages
Overlay |
Panel |
Door |
Frame |
Tenon Center |
Gasket | 13/32" (11) |
| |
| Diameter |
| Glass |
| 1/4" (6) |
| Diameter |
Top Door Hinge
Shipping
Screws
Bottom
Door Hinge
Shipping
Screws
Illus. 9
Illus. 10 | Illus. 11 | Illus. 12 |
11
