Sub-Zero 430/F, 430/O, 424/O installation instructions Panel Grille, Soffit

MODEL 430 I N S TA L L AT I O N I N S T R U C T I O N S

M O D E L 430 GRILLE R E M O VA L

In order to prevent damage to the grille and to access the power cord, the top grille assembly should be removed prior to moving the unit.

Framed grille: Remove three counter-sunk grille screws at the bottom of the grille and cut the red nylon shipping strap. NOTE: Grille screws are accessed with the door open. Then tilt the grille forward and release the springs from behind the grille. Refer to illustration 1 below.

Overlay panel grille: First, remove the inner grille panel assembly as shown in illustration 2 below. Lift up, then pull out at the bottom, pull the top section down and out of the top key slot. Remove the four mounting screws that hold the outer grille panel assembly to the top compartment. Refer to illustration 3.

ANTI - TIP B L O C K I N G K I T

To prevent the unit from tipping forward and provide a stable installation, the unit must be secured in place with an anti-tip blocking device.

An anti-tip blocking kit (wood block and hardware) is provided with the Model 430.

If there is a solid soffit above the unit with clearance between the unit and the soffit of 1"

(25)or less, you won't need to block the unit. For installations with clearances of more than 1" (25), you must install the anti-tip blocking kit, to prevent tipover in case several loaded wine shelves are extended at the same time.

Locate and mark two wall studs against the wall where the unit will be installed. Then locate the proper height to clear the unit. The space between the unit top and the bottom of the wood block must not be more than 1/4" (6).

Position the wood block over the unit and use the screws and ‘L‘ brackets to lock it in place. Make sure the screws extend a minimum of 7/8" (22) into each of the two wall studs. The wood block must be positioned securely and must extend at least 3" (76) over the unit. Refer to illustration 5 on page 27.

Using the front and rear leveling legs, raise the unit until it makes contact with the wood block. See Level the Unit on page 27.

Grille Springs

Grille

Screws

(inside door)

Illus. 1

Inner Grille	3
Panel Assembly
3
	2
2
1	1

Illus. 2

Panel Grille

Frame

Illus. 3

Soffit

1"(25)

Illus. 4

26