Sub-Zero 424/O, 430/O, 430/F installation instructions Door Frame

MODEL 430 I N S TA L L AT I O N I N S T R U C T I O N S

DOOR P A N E L S

Model 430 is offered in three design applica- tions; stainless steel (/S), framed (/F) and overlay (/O). Each of these designs is available as a glass door (G) model.

The stainless steel Model 430 is available in the classic finish only and is shipped from the factory with the decorative stainless steel door panel and matching handle in place.

The framed Model 430/F accepts a decorative front panel which is inserted into the door frame channel. This panel will be provided by the customer. The handle is included as part of the door frame system.

The overlay Model 430/O is designed to accept a decorative door panel to match surrounding cabinetry. This door panel and the handle will be provided by the customer.

Before beginning installation, check for the correct components for the fit and finish desired. All models require a decorative panel a minimum of 5/8" (16) thick.

FRAMED D O O R PA N E L

Inspect the door panel for the minimum 5/8"

(16)thickness, the required 1/4" (6) routing around the perimeter, as shown in illustration 11 on page 30, and the finished inside edge. The door panel has a weight limit of 25 lbs (11 kg). See the Wine Storage section of the Sub-Zero Design Guide for additional panel information.

Remove the door handle to install the panel. The handle screws are hidden by a magnet- backed trim molding. Remove the molding using a piece of tape to pull it away from the handle and expose the handle screws. The molding will bend at the center so you can remove it. Refer to illustration 9 below.

With a Phillips screwdriver, remove the handle from the door. Slide the panel into the channels provided by the trim extrusions on the door. With the door panel in position, replace the handle. This is an extended version of the standard Sub-Zero handle, so no routing of the door panel should be required for proper finger clearance. Be sure the panel is inserted completely into the channels for proper fit and alignment. Refer to illustration 10.

Replace the trim moldings by inserting the top, then the bottom into the handle channel. Release the middle and set the magnets.

M O D E L 430

PA N E L

D E S I G N

Additional panel design information can be found in the Sub-Zero Design Guide. Check our website at subzero.com.

Door

Frame

Illus. 9

Trim

Panel

Illus. 10

29