MODEL 430 I N S TA L L AT I O N I N S T R U C T I O N S
M O D E L 430 | HOME ALARM C O N N E C T I O N S |
Before the kickplate and grille are installed, all necessary wiring connections in the compres- sor compartment should be completed.
If a home alarm system is to be installed on the Wine Storage unit, the connections should be made using the logic supplied with the alarm specifications. See illustration 7 below for the appliance lead locations, and refer to the following for color codes:
Normally open contacts – white with red stripe wire
Normally closed contacts – white with blue stripe wire
Common – gray with white stripe wire
Use the 1/4" (6) spade terminals or wire nuts provided to make the proper wiring connec- tions.
IMPORTANT NOTE: If you are not responsible for alarm system connection, this information should be supplied to the home security system contractor.
The alarm circuit in the unit is intended as
a
Any unused terminals should be completely insulated and all wires should be secured away from conductive or moving components.
KICKPLATE A N D GRILLE
After the unit has been leveled, make sure the drain pan is installed properly and install the kickplate. Refer to illustration 8 below.
IMPORTANT NOTE: The kickplate must be removed for servicing. The floor cannot inter- fere with removal. Refer to label mounted on the kickplate support for height clearance.
IMPORTANT NOTE: The floor under the Wine Storage unit must be at the same level as the surrounding finished floor to allow for removal of the unit for servicing.
Replace the grille by reversing the procedure outlined on page 26. If you’re using a panel grille, see Overlay Grille Panel on page 31.
Turn power back on to the electrical outlet.
Home Alarm |
Connections |
Illus. 7 | Illus. 8 |
Dimensions in parentheses are in
28 | millimeters unless otherwise specified. |
