Sub-Zero 424/O, 430/O, 430/F installation instructions U N I T A N C H O R E D To C A B I N E T Ry

MODEL 430 I N S TA L L AT I O N I N S T R U C T I O N S

A N C H O R T H E U N I T
After door and side panels have been installed,		U N I T A N C H O R E D TO C A B I N E T RY
the unit has been leveled and door adjustment			First, make sure units have been leveled
completed, anchor the unit to the opening.
			and aligned, and doors adjusted.
This will assure a proper fit and a secure
			Drill three 3/16" holes through both outer
installation. The Sub-Zero Anchoring Kit (part
#4200900), available from your Sub-Zero			trims. Refer to illustration 16 below.
dealer, includes the necessary hardware.			Drill a 1/8" pilot hole into the cabinetry.
IMPORTANT NOTE: Be sure to level and
			Install all six Sems.
square the unit before anchoring it.
T W O U N I T S A N C H O R E D TO G E T H E R
			Do not drill through the model and serial
	Drill three 13/64" holes through the middle
			number plate.
	trim of both units.
	Using the Loctite on the screws, install the
	three Chicago screw posts.
	Recheck the units for level.
	Drill three 3/16" holes through both outer
	trims. Refer to illustration 15 below.
	Using a 1/8" drill bit, drill into the cabinetry
	for a pilot hole.
	Install all six Sems to the cabinetry.

M O D E L 430

O P T I O N A L

C O M P O N E N T S

Optional installa- tion components are available through your Sub-Zero dealer, or call Sub-Zero at 800-222-7820.

You can also visit our website at subzero.com.

Illus. 15 Illus. 16

33