Sub-Zero 430/F Solid Door Pa N E L S, 427 427R, Top Of Template Flush With Top Of Drawer Panel

M O D E L S

427 427R

PA N E L

D E S I G N

Additional panel design information can be found in the Sub-Zero Design Guide. Check our website at subzero.com.

MODELS 427 A N D 427R I N S TA L L AT I O N

MODEL 427R D R AW E R PA N E L S

IMPORTANT NOTE: Drawer panels for Model 427R must be a minimum of 5/8" (16) thick and cannot exceed 12 lbs (5 kg) for each panel.

Remove the mounting hardware provided and set aside. You should work on the back side of each drawer panel and you should protect the fronts of these panels.

Position the top edge of the drawer template flush with the top edge of each drawer. For the top drawer, there is only one place for the lower mounting bracket to be placed. However, depending on the depth of the lower drawer panel, you have two options for placement of the bracket. Refer to illustration 13 below.

Secure the template in place with tape or small clamps and mark positions for your pilot holes. Remove template. Drill pilot holes and place the hardware in the proper place (dog-ear bracket on top) and fasten securely with the #8 x 1/2" screws provided. See illustration 14.

To help with proper placement of drawer panels, examine the lower panel mounting bracket and determine which slotted holes to use. Position screws into the lower portion of the drawer that correspond with these slotted holes. Leave these screws out a small distance so they can help when you mount the drawer panels to the drawer.

With the two brackets in place on the drawer panel, engage the top dog-ear bracket first and then the lower bracket onto the protruding screws. You will have a 1/4" (6) adjustment up and down and side to side in each drawer panel. Fasten all screws to the lower bracket to secure the drawer panel.

IMPORTANT NOTE: Once drawer panels have been adjusted for proper spacing, be sure to reconnect the control cable on the upper drawer after you have installed the drawer. Refer to illustration 3 on page 15.

SOLID DOOR PA N E L S

IMPORTANT NOTE: The solid door panel for Models 427 and 427R must be a minimum of

5/8" (16) thick and cannot exceed 40 lbs (18 kg).

Installation of the solid door panel is the same as the door panel for a glass door model.

A solid panel must not be installed on a glass door unit, as this may cause moisture to form behind the panel.

Top Of Template

Flush With Top Of

Drawer Panel

Gap On Side

Edges Will Vary

According To

Design

Back Of

Drawer Panel

Illus. 13 Illus. 14

22