Sub-Zero 430/F, 430/O, 424/O installation instructions Hinge A D J U S T M E N T

MODEL 430 I N S TA L L AT I O N I N S T R U C T I O N S

M O D E L 430

HINGE A D J U S T M E N T I N S TA L L AT I O N C H E C K L I S T

O P T I O N A L

C O M P O N E N T S

Optional installa- tion components are available through your Sub-Zero dealer, or call Sub-Zero at 800-222-7820.

You can also visit our website at subzero.com.

IMPORTANT NOTE: The unit must be installed and leveled before adjusting the door hinges.

Check to make sure the door is properly adjusted. If not, adjust the top or bottom door hinge by first removing and discarding the two small shipping screws. Refer to illustration 17 below. Adjust the top hinge left to right and in or out by loosening the three allen head screws. Adjust the bottom hinge by loosening the four allen head screws with a 1/8" (3) allen wrench. Refer to illustration 18. The door will now be able to move left to right or in and out.

9 0 - D E G R E E DOOR STOP

An optional 90-degree door stop kit for Model 430 is available through your Sub-Zero dealer.

COMPLETING T H E I N S TA L L AT I O N

IMPORTANT NOTE: When you have completed the installation of the Model 430 Wine Storage unit, refer to the following Installation Checklist and Service Information.

The importance of the installation of the Sub-Zero Wine Storage unit cannot be overemphasized. Proper installation is the responsibility of the selling dealer or installer.

IMPORTANT NOTE: To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been over- looked.

Any questions or problems regarding the installation should be directed to your Sub-Zero dealer or the Sub-Zero Customer Service Department at 800-222-7820. You may also check the Contact & Support section of our website, subzero.com.

Illus. 17 Illus. 18

	Dimensions in parentheses are in
34	millimeters unless otherwise specified.