Sub-Zero 430/F, 430/O, 424/O Framed D O O R Pa N E L, Overlay D O O R Pa N E L

MODEL 430 I N S TA L L AT I O N I N S T R U C T I O N S

M O D E L 430

FRAMED D O O R PA N E L OVERLAY D O O R PA N E L

PA N E L

D E S I G N

Additional panel design information can be found in the Sub-Zero Design Guide. Check our website at subzero.com.

Install the #8 x 5/8" screws through the back of the glass door frame into the door panel. Refer to illustration 11 below.

IMPORTANT NOTE: The door panel should not be relied on to remain straight and flat by itself. Secure it to the wine storage unit door with the screws provided.

After the door panel installation is complete, apply the cover patches or plugs provided over the holes on the inside surface of the door.

The cover patches or plugs are part of the insulation system on the door of the Wine Storage unit. Be sure to cover all the holes in the door that were used.

If your customer has chosen an overlay design door and grille panel, the unit will be shipped without handle and hardware. The cabinet manufacturer or designer will provide handle hardware at the job site to match the overall decorating scheme. We recommend larger D- style pulls. The use of small, one-piece knobs is not recommended.

The metal frame on the glass door has numerous mounting holes on each side of the door. This is to accommodate the Sub-Zero accessory handles and provide for easy attach- ment of the handle through the door frame.

If you choose not to use these pre-drilled mounting holes, you must either drill addi- tional holes through the metal frame of the door, or attach the handle through the door panel only.

If you attach through the door panel only, the handle must be attached before the door panel is installed and the handle screws will need to be set into the rear surface of the door panel.

If you choose to drill through the metal door frame, this must be done before the handle holes are located and drilled in the panel.

Illustration 12 shows how this hole passes through the door frame. The hole center is on the small locator groove in the front of the frame. A 1/4" (6) diameter hole is made in the front wall of the extrusion and a 13/32" (11) diameter hole through the rest of the frame.

Gasket

Glass

Rail or Stile

Rout to 1/4" (6) thickness

Illus. 11

Dimensions in parentheses are in

30 millimeters unless otherwise specified.

Gasket	13/32" (11)
	Diameter
	Glass
	1/4" (6)
	Diameter

Illus. 12