Sub-Zero 430/O, 424/O, 430/F MODEL 430 I N S TA L L AT I O N I N S T R U C T I O N S

MODEL 430 I N S TA L L AT I O N I N S T R U C T I O N S

M O D E L	430	MODEL 430 I N S TA L L AT I O N
		I N S TA L L AT I O N S P E C I F I C AT I O N S
		24"
		(610)
		ROUGH
		OPENING
		DEPTH
		TOP VIEW

	ANTI-TIP BLOCK
	7"	E
	(178)
		6"
		(152)
	LOCATE ELECTRICAL
	WITHIN SHADED AREA
833/4" (2127)	291/2"
ROUGH OPENING	(749)
HEIGHT	ROUGH OPENING WIDTH
TO FINISHED
FLOORING WITH
STANDARD		751/2"
11" (279) GRILLE
83" (2108)		(1918)
MIN HEIGHT
REQUIRED
(LEVELERS IN)

S I T E P R E P A R AT I O N

Make sure that the finished rough opening where the Wine Storage unit is to be installed is properly prepared. Refer to the Installation Specifications illustration for rough opening dimensions, door swing clearance and electri- cal placement for Model 430.

If you are installing two Model 430 units side by side, or a Model 430 and a Built-In model, a separating filler strip is recommended. Add the filler strip width to the finished rough opening dimension. Complete the installation with the Anchoring Kit (part #4200900), see page 33.

IMPORTANT NOTE: To operate properly,

the door must open a minimum of 90 degrees. Use a minimum 3" (76) filler strip in corner installations to assure a 90-degree door opening. Allow enough clearance in front of the unit for full door swing.

IMPORTANT NOTE: Make sure the floor under the unit is level with the surrounding finished floor.

Do not load wine into the Wine Storage unit until the installation is complete.

FRONT VIEW

90˚

33" (838)

DOOR CLEARANCE

301/8"

(765)

237/8"

(606)

BEHIND FRAME

130˚
MAXIMUM
	301/8"
DOOR SWING
	(765)

50" (1270)

DOOR CLEARANCE

NOTE: Door swing clearances are based on stainless steel door and handle dimensions.

24