MODELS 427 A N D 427R I N S TA L L AT I O N
POSITION T H E U N I T
M O D E L S
427 427R
Installation for Concrete Wedge Anchors:
1)Drill a 3/8" (10) diameter hole any depth exceeding the minimum embedment. Clean the hole or continue drilling additional depth to accommodate drill fines. Use a carbide drill bit manufactured within ANSI
2)Assemble the washer and nut flush with the end of anchor to protect threads. Drive the anchor through the material to be fastened until the washer is flush with the surface material.
3)Expand the anchor by tightening the nut
Always wear safety glasses and use other necessary protective devices or apparel when installing or working with anchors.
Anchors are not recommended for use in lightweight masonry material such as block or brick, or for use in new concrete which has not had sufficient time to cure. The use of core drills is not recommended to drill holes for the anchors.
Before moving the Wine Storage unit into position, secure the door closed. Remove the drawers of the Model 427R.
IMPORTANT NOTE: For Model 427R, the top drawer has a control cable that needs to be disconnected before removing this drawer. Refer to illustration 3 below for placement and how to disconnect this fitting.
For Model 427R, the drawers should be placed aside until you are ready for installation of the door and drawer panels.
IMPORTANT NOTE: When two Model 427, 427R or Integrated units are installed closer than 2" (51) to one another, it is necessary to use the
O P T I O N A L
C O M P O N E N T S
Optional installa- tion components are available through your
You can also visit our website at subzero.com.
Illus. 3
Dimensions in parentheses are in |
|
millimeters unless otherwise specified. | 15 |
