Sub-Zero 430/F, 430/O 427 427R, W O O D F L O O R A P P L I C At I O N S, Dimension A, 131/2

MODELS 427 A N D 427R I N S TA L L AT I O N

M O D E L S ANTI - TIP BRACKET I N S TA L L AT I O N

427 427R

To prevent the unit from tipping forward and provide a stable installation, install the anti-tip bracket and extend the front leveling legs to the floor.

An anti-tip bracket and hardware is provided with the Wine Storage unit. The anti-tip bracket must be installed on a solid base to prevent tipover in case several loaded wine shelves are extended at the same time.

If you are installing the Model 427 or 427R in a space deeper than 24" (610), the anti-tip bracket must be installed no more than 24"

(610)deep, so it engages the unit properly. It is important that this measurement be made from the front of the unit without panels, to the back of the anti-tip bracket.

W O O D F L O O R A P P L I C AT I O N S

Use the six #12 x 21/2" wood screws and the six 1/4" flat washers provided. Drill pilot holes 3/16" (5) diameter maximum, and be sure that the screws penetrate through the flooring material and into the wall plate a minimum of 3/4" (19). Be sure that the screws hold tight. Refer to illustration 1 below.

C O N C R E T E F L O O R A P P L I C AT I O N S

Use the two 3/8" x 3 3/4" concrete wedge anchors, two #12 x 21/2" wood screws and two 1/4" flat washers provided. Be sure that the anchors and screws hold tight. Refer to illus- tration 2 below.

IMPORTANT NOTE: In some installations the subflooring or finished floor may require angling the wood screws used to fasten the anti-tip bracket to the back wall. Refer to illus- trations 1 and 2 below.

Make sure that there are no electrical wires in the area which the screws could penetrate.

S P E C I F I C A T I O N S

Dimension A 131/2" (343)

Finished Flooring

Underlayment

Wall Plate

Subflooring

WOOD FLOOR

Illus. 1

Finished Flooring
	Underlayment
	Wall Plate
	Subflooring
11/2"	CONCRETE
min
(38)	FLOOR

Illus. 2

14