Sub-Zero 430/O, 424/O Stainless Steel D O O R P A N E L, Overlay Glass D O O R Pa N E L, 427 427R

M O D E L S

427 427R

MODELS 427 A N D 427R I N S TA L L AT I O N

STAINLESS STEEL D O O R P A N E L OVERLAY GLASS D O O R PA N E L

PA N E L

D E S I G N

Additional panel design information can be found in the Sub-Zero Design Guide. Check our website at subzero.com.

Before installing the stainless steel door panel, check the panel carefully. Options are available for kickplate/grille height, overall height, door swing and door lock.

The stainless steel panel is mounted to the door by passing the #8–32 x 5/8" screws provided, through holes in the door frame from the rear, and into the threaded holes in the door panel. Refer to illustration 10 below. The screw holes inside the door are hidden under a cover flap on the door gasket. It is necessary to lift the flap to insert the screws.

After the door panel installation is complete, apply the cover patches or plugs provided over the holes on the inside surface of the door.

For installation of stainless steel panels on Model 427R drawers, see Model 427R Drawer Panels on page 22.

The cover patches or plugs are part of the insulation system on the door of the Wine Storage unit. Be sure to cover all the holes in the door that were used.

Inspect the door panel for the minimum 5/8"

(16)thickness, the greater width requirements for the stiles (to cover the door hinges), and the finished inside edge. The door panel has a weight limit of 20 lbs (9 kg). See the Wine Storage section of the Sub-Zero Design Guide for additional panel information.

Decide if the handle will be attached through the glass door frame or just through the deco- rative door panel. If it is just through the door panel, the handle must be attached first.

If a lock is to be used, the body of the lock should be installed on the door panel after the panel is mounted.

Decorative panels are attached to the Model

427and 427R door using #8 x 5/8" square drive screws passing through the door frame from the rear, behind the gasket into the panel. The door panel is marked for screw locations by the use of ‘tenon centers’, which are temporar- ily inserted into the 1/4" (6) diameter holes in the front of the glass door frame. Refer to illustration 11 below.

Stainless	Door
Steel	Frame
Panel
	Back of
	Stainless Steel
	Panel

Illus. 10

Integrated	Door
Panel	Frame
	Tenon Center

Illus. 11

Gasket	13/32" (11)
	Diameter
	Glass
	1/4" (6)
	Diameter

Illus. 12

20