Sub-Zero ICB700TCI, ICB700TFI, ICB700TR installation instructions P Lu M B I N G Requirements

Models: ICB700TR ICB700TCI ICB700TFI

1 104
Download 104 pages 47.94 Kb
Page 10
Image 10
P LU M B I N G REQUIREMENTS

I N T E G R AT E D INSTALLATION SPECIFICATIONS

ACCESSORIES

Optional acces- sories are available through your Sub-Zero dealer. To obtain local dealer information, visit our website, subzero.com.

P LU M B I N G REQUIREMENTS

For Integrated models with an automatic ice maker, rough in the water supply line. Connect the 6,35 mm water line from the ice maker water valve to the copper water supply. Use an easily accessible shut-off valve between the water supply and the unit. This shut-off valve should not be installed behind the unit. Do not use self-piercing valves. A saddle valve kit (part #4200880) is available from your Sub- Zero dealer.

The Installation illustrations on pages 6–8 show the precise placement of the water line. When routing through the side walls, you must place the water line within 13 mm of the floor and as close as possible to the back wall.

The line must be routed around the anti-tip bracket so it clears the bracket and the leveling feet of the unit. Refer to the top view in the Installation illustration for your unit on pages 6–8. Regardless of the routing, allow for 686

mmof excess water line to remain outside the wall or floor for easy connection to the unit.

IMPORTANT NOTE: Do not route the water supply line in front of the compressor tray. The tray must be slid forward for service.

A line filter is required when water conditions have a high sediment content. The ice maker operates on water pressure of 1.4 bar to

6.9 bar.

A reverse osmosis system can be used, provided there is a consistent water pressure of 1.4 bar to 6.9 bar supplied to the water valve at all times.

IMPORTANT NOTE: In some cases a reverse osmosis water filter system may not be able to maintain the minimum water pressure consistently.

10

Page 10
Image 10
Sub-Zero ICB700TCI, ICB700TFI, ICB700TR installation instructions P Lu M B I N G Requirements