Sub-Zero ICB700TR, ICB700TFI I N S Ta L L At I O N Recommendations, Tools And Materials Required

I N T E G R AT E D INSTALLATION RECOMMENDATIONS

I N S TA L L AT I O N RECOMMENDATIONS
The importance of the installation of the	TOOLS AND MATERIALS REQUIRED
Sub-Zero Integrated unit cannot be overem-	The following is a list of tools and materials
phasized. Installation should be done by a
	that should be available for proper installation.
qualified installer.
Before you begin the installation process,		Phillips screwdriver set
it is recommended that you read this entire
Installation Instructions book. There are key		Slotted screwdriver set
details that you should take special care to		1.2 m of 6,35 mm copper tubing and saddle
observe during the installation. By reading
		valve for the water line—part #4200880
these instructions carefully, you will make the
		(do not use self-piercing valves)
installation process easier, problem-free and,
most importantly, safe.		Copper tubing cutter
Any questions or problems about the		Level—.6 m and 1.2 m recommended
installation should be directed to your		Appliance dolly able to support 227 kg
Sub-Zero dealer. You can also visit our website
		and adequate help to handle the weight of
at subzero.com.
		the unit
SITE PREPARATION		Various sized pliers
		Wrench set
Make sure that the finished rough opening
		Allen wrench set
where the Integrated unit is to be installed is
properly prepared. Refer to the Overall		11 mm hex bolt nut driver
Dimensions and Installation illustrations for		Crescent wrenches
your specific model on the following pages.
Make sure that the rough opening dimensions,		Drill and assorted drill bits
door and drawer clearances, electrical service		Masonite, plywood, 3,175 mm pressed
and plumbing are correct for the model you
		fiberboard, cardboard or other suitable
are about to install.
		material to protect finished flooring
Be sure that the plumber, electrician and		Appropriate materials to cover and protect
cabinet installer have this information before
		the home and its furnishings during
finishing work is completed.
		installation
IMPORTANT NOTE: The inside edges of the
rough opening, as well as the sides and a
portion of the backside of the decorative
panels will need to be finished, as they will be
exposed when the doors are open.

5