I N T E G R AT E D INSTALLATION INSTRUCTIONS
WAT E R L I N E C O N N E C T I O N |
| |
QUICK CONNECT WATER VALVE | In areas with water of high mineral content, | |
For units with an ice maker, the quick connect | the use of an | |
mended. Make sure the filter is positioned and | ||
water valve and PEX tubing are located on the | ||
accessible for replacement when necessary. | ||
IMPORTANT NOTE: The ice maker will not | ||
Follow these instructions to connect the ice | ||
maker water line. | fill with water immediately. Allow 24 hours for | |
Attach the union fitting to the copper house | proper ice production. Let your customer know | |
that the first container filled with ice should be | ||
water supply line. Pull the coiled gray PEX | ||
discarded, as with any new connection there | ||
tubing with a red cap and captured metal nut | ||
may be impurities in the ice from the water | ||
toward the house water supply line. Remove | ||
supply line. | ||
and discard the red cap, then attach the tubing | ||
| ||
to the union with captured nut. Tighten all |
| |
connections. Recoil the excess tubing under |
| |
the unit. Refer to illustration 10 below. |
|
Shut power off at the circuit breaker before making electrical connection to the solenoid, if required.
IMPORTANT NOTE: Turn on the water supply and check all fittings for leaks. Make certain the electrical harness is attached to the solenoid.
PEX |
Tubing |
Illus. 10
17