I N T E G R AT E D INSTALLATION INSTRUCTIONS
A N T I - T I P B R AC K E T I N S TA L L AT I O N |
|
|
|
| |
WOOD FLOOR APPLICATIONS | CONCRETE FLOOR APPLICATIONS | ||||
Use the six #12 x 63,5 mm wood screws and | Use the two #10 x 95,25 mm concrete wedge | ||||
the six #12 flat washers provided. Drill pilot | anchors, two #12 x 63,5 mm wood screws and | ||||
holes 5 mm diameter maximum, and be sure | two #12 flat washers provided. Be sure that the | ||||
that the screws penetrate through the flooring | anchors and screws hold tight. Refer to | ||||
material and into the wall plate a minimum of | illustration 2 below. | ||||
19 mm. Be sure that the screws hold tight. | IMPORTANT NOTE: In some installations the | ||||
Refer to illustration 1 below. | |||||
subflooring or finished floor may require | |||||
| |||||
| angling the wood screws used to fasten the | ||||
| |||||
| illustrations 1 and 2. | ||||
|
|
|
| ||
|
|
|
|
| |
| Make sure that there are no electrical |
| |||
| wires or plumbing in the area which the |
| |||
| screws could penetrate. |
| |||
|
|
|
|
|
Finished Flooring |
Underlayment |
Wall Plate |
Subflooring |
WOOD FLOOR
Illus. 1
Finished Flooring | |
| Underlayment |
| Wall Plate |
| Subflooring |
38 |
|
mm | CONCRETE |
min | FLOOR |
|
Illus. 2
S P E C I F I C A T I O N S |
|
Dimension A |
|
686 mm Wide Units | 343 mm |
914 mm Wide Units | 457 mm |
13