Sub-Zero ICB700TFI K I C K P L At E / G R I L L E Installation, Back Of Door Panel, Gap On Side

I N T E G R AT E D INSTALLATION INSTRUCTIONS

PANEL REQUIREMENTS

Door and drawer panels must be a minimum of 16 mm thick.

The door panel cannot exceed 18 kg and each drawer panel must not exceed 5 kg for 686

mmwide units. For

914 mm wide units, the door panel weight limit is 24 kg and 7 kg for each drawer panel.

K I C K P L AT E / G R I L L E INSTALLATION

Once your Integrated unit is secured, the kickplate/grille can be installed. There is some adjustment to the mounting assembly so that this decorative piece can fit flush with the surrounding area. Refer to illustration 11 below.

Turn power back on to the electrical outlet.

IMPORTANT NOTE: The unit must be allowed to have ventilation through the fins of the kick- plate/grille. You may cover the solid area, but do not block the fins. The lower drawer panel may hang in front of the fins, but your base- board molding must not cover them.

IMPORTANT NOTE: The kickplate/grille must be removed for servicing. The floor cannot interfere with removal.

NOTE: The kickplate/grille can be painted another color, if you choose. Follow these easy steps:

Rough up the surface to be painted with fine grit sandpaper.

Wipe with alcohol to ensure that the surface is clean and dry.

Use an appliance or industrial grade, oil base, high gloss enamel paint.

PA N E L I N S TA L L AT I O N

The integrated design uses custom wood or other decorative panels and handles provided by the customer. Stainless steel panels

are available as sales accessories through your Sub-Zero dealer. To obtain local dealer infor- mation, visit our website, subzero.com.

Before beginning installation, check the panels for the proper fit and finish desired.

Door and drawer panels must be a minimum of 16 mm thick. The door panel cannot exceed 18 kg and each drawer panel must not exceed 5 kg for 686 mm wide units. For 914 mm wide units, the door panel weight limit is 24 kg and 7 kg for each drawer panel.

D-style pulls are recommended for handle hardware. Handles should be located on the opposite side from the hinge, centered on the cabinet door, and on the top center area of the drawer panel. Screw heads may have to be countersunk to ensure that the hardware does not interfere with the panels fitting flush with the unit's door or drawers.

It is recommended that the door panel of the tall unit be installed first and then the upper and lower drawer panels.

Illus. 11

18

Back Of Door Panel

Gap On Side

Edges Will Vary

According To

Design

Bottom Of Template

Flush With Bottom

Of Door Panel

Illus. 12