Sub-Zero ICB700TR, ICB700TFI, ICB700TCI Door And Drawer Panels, Side Panels

I N T E G R AT E D INSTALLATION INSTRUCTIONS

PA N E L CONSIDERATIONS
DOOR AND DRAWER PANELS	SIDE PANELS
To install door and drawer panels, refer to the	Side panels for integrated models are not
instructions under Panel Installation on page	attached to the unit. You must securely fasten
18. You should check panel dimensions and	the panels to adjacent cabinets and floor.
placement before proceeding with installation	Panels should be fastened to the floor and
of the Integrated unit. If you have questions,
	walls using ’L’ brackets (hardware not
contact your Sub-Zero dealer or cabinet
	provided). To help you move the unit into
supplier. Instructions regarding sizing of the
	place, rout out an area in the floor so the ’L’
panels are provided in the Sub-Zero Design
	bracket will sit flush with the floor level.
Guide.
	Brackets and screws are provided for
IMPORTANT NOTE: A portion of the backside	mounting the unit to adjoining cabinets and
of the decorative panels will need to be	side panels. On the tall units, there are four
finished, as they will be exposed when the	side mounting clips on each side and on the
doors are open.	base units, there are two per side. Side panels
	must be a minimum of 19 mm thick.
	IMPORTANT NOTE: For installations where
	you are not attaching to a side wall or you are
	installing two Integrated units together, you
	must remove the clips before moving the unit
	into place. After removing the clips, replace
	the screws in the holes and discard the clips.
	Optional components are necessary for
	anchoring two Integrated units together. Refer
	to Dual Installations on page 21. Optional
	components are available through your
	Sub-Zero dealer. To obtain local dealer infor-
	mation, visit our website, subzero.com.

PANEL

DESIGN

Additional panel design information can be found in the Sub-Zero Design Guide. Check our website at subzero.com.

11