1.Establish a connection to the switch using either a serial connection or a Telnet connection.
Refer to the SunSwitch 1.1 Installation and Configuration Guide
2.At the Main# prompt, type cfg to display the Configuration menu and prompt (Configuration#).
>> Main# cfg [Configuration Menu]
sys | - | |
port | - | Port configuration menu |
ip | - | IP addressing menu |
vlan | - | VLAN configuration menu |
stp | - | Spanning Tree menu |
snmp | - | SNMP menu |
setup | - | Step by step configuration set up |
dump | - | Dump current configuration to script file |
>> Configuration#
3.Type the following to disable autonegotiation on a GigaSwift Ethernet port. Replace portnumber with the Ethernet port used by the adapter.
>>Configuration# /port portnumber/auto off
4.Type the following to apply and save your changes.
>>Configuration# apply
>>Configuration# save
Refer to the switch documentation for further configuration instructions.
▼To Set Autonegotiation to off for Other Noncompliant Network Equipment
If your network equipment does not support autonegotiation, you can set autonegotiation to off on the GigaSwift Ethernet (ce) device.
Appendix B Diagnostic Software and Troubleshooting Issues 57
