Sun Microsystems CP3000 Getting Started, Important Safety Information for Sun Hardware Systems

C H A P T E R 1

Getting Started

This chapter provides information and procedures needed to install and make the Sun Netra CP3000 AMC.1-HDD SAS disk operational. This chapter should be read before unpacking and installing the AMC.

In addition to this chapter, refer to the following safety document:

Important Safety Information for Sun Hardware Systems (816-7190)

Caution – When the system is plugged in, energy hazards are present on the midplane. Do not reach into the enclosure while the power is on.

Caution – Static electricity can damage electronic components. Wear a wrist strap grounded through one of the system’s ESD ground jacks when removing and replacing hot-swappable components.

This chapter contains the following topics:

■Section 1.1, “System Requirements” on page 1-2

■Section 1.2, “Unpacking” on page 1-3

■Section 1.3, “Handling AMCs” on page 1-4

■Section 1.4, “AMC Faceplate” on page 1-5

■Section 1.5, “AMC LEDs” on page 1-6

■Section 1.6, “Removing and Installing AMCs” on page 1-8

■Section 1.7, “Enabling and Disabling SAS Ports” on page 1-18

1-1