Push the ejector latch in fully | Sun Microsystems CP3000 specification

FIGURE 1-7Inserting the AMC Into a Blade Server

8.Push the ejector latch in fully.

If system power is on and AMC is installed properly, the AMC board Hot-Swap LED lights up. The Hot-Swap LED blinks for several seconds, then goes off.

If the Hot-Swap LED does not go off after several seconds, push firmly on the injector/ejector handles to ensure that they are pushed in all the way.

Chapter 1 Getting Started 1-17

Image 27

Sun Microsystems CP3000 manual Push the ejector latch in fully, 7Inserting the AMC Into a Blade Server

Contents

For the AMC.1-HDD SAS Disk Please Recycle Contents Managing the AMC Overview Agency Certifications Configuring the AMCConnectors and Ports Environment Specifications Index Index-1 Typographic Conventions Preface Third-Party Web Sites Related Documentation Sun Welcomes Your Comments Page Getting Started Important Safety Information for Sun Hardware Systems Blade Server Compatibility System RequirementsOperating Systems Compatibility Chassis Compatibility Electrical and Environmental Unpacking Handling AMCs 1AMC.1-HDD SAS Disk Faceplate AMC Faceplate 1AMC Status LEDs AMC LEDs 2Hot-Swap Blue LED States Removing and Installing AMCs Removing an AMCShut down the payload OS Hot-Swap LED starts blinking 2Deactivating the AMC 3Removing the AMC Remove the AMC 4Front Cable Management Bracket in Lower Position Removing a Blade Server and AMC Remove the filler panel, if necessary Installing an AMC 5Sample Top View Obtain the AMC card from the ship kit 6Opening the Injector/Ejector Latch Page 7Inserting the AMC Into a Blade Server Push the ejector latch in fully Enabling and Disabling SAS Ports To Enable AMC Port 2 Driven by Port 1 of SAS ControllerTo Enable AMC Port 3 Driven by Port 2 of SAS Controller Power on the system, if necessary To Disable AMC Port 3 Driven by Port 2 of SAS Controller To Disable AMC Port 2 Driven by Port 1 of SAS ControllerPage Overview Features Power Regulator Key ComponentsHard Drive Disk SAS Controller FlashModule Management Controller MMC Port Connectors Faceplate and LEDsLEDs OOS Technical Support and Warranty Functional DiagramPage 4Sun Netra CP3000 AMC.1-HDD SAS disk Barcode Labeling Disposal Managing the AMC Supported Ipmi Commands Monitoring and Control FunctionsIpmi Controller 1Supported Ipmi Commands 2Standard FRU Data Records FRU Information 3Threshold Sensors Sensors Readme files within the download package Firmware and Software Upgrades Configuring the AMC Boot Bios Utility Configuration Tools Features and Configurations Launching the Boot Bios UtilityPress Ctrl C Page 2Adapter Properties Menu OpenBoot Bios Enabling and Disabling Channel Ports Extensible Firmware Interface EFI Connectors and Ports Connector Locations and Assignments Connector PinoutsTable A-1Pin Assignments Appendix a Connectors and Ports SAS Controller Ports 1AMC e-Keying Port Assignments Keying PortsPage Environment Specifications Electrical Table B-1Electrical SpecificationsTable B-2Environmental Specifications Electrical and Environmental RPM Table B-3MTBF Values by Temperature Reliability Absolute Maximum RatingsNormal Operating Ranges Board Dimensions and Weight AMC.1-HDD SAS disk PCB DimensionsMechanical Page Agency Certifications NEBS/ETSI CE Certification Safety Emissions Test Regulations 1 EN 55022 Emissions2 EN 55024 Immunity Regulatory Information FCC USAIndustry Canada Canada Page Numerics Index NEBS/ETSI, C-2