Sunbeam 2360, 2356 Assembling The Stand Mixer, Attaching The Turntable, Attaching The Mixer Head

ASSEMBLING THE STAND MIXER

Before assembling the mixer, be sure the Mix-Finder®dial is in the ZERO position and the electric cord is unplugged.

ATTACHING THE TURNTABLE

Place the revolving turntable into

the base of the stand using the socket corresponding to the size of the bowl.

Ball Bearing

Extension

Small	Large
	Bowl
Bowl

ATTACHING THE MIXER HEAD

Press in on the mixer-release trigger, located at the rear of the stand.

For models equipped with a head lock feature – While pressing in on the mixer-release trigger, press in on the head-lock latch. This is best accomplished by using the thumb and forefinger of the same hand and pressing inward.

This will open the top of the stand to receive the mixer head. Place the mixer head on the top of the stand so that the metal pivot, located on the bottom of the mixer head, goes into the open groove on the top of the stand.

Mixer

Head

Metal

Mixer-Release		Pivot
Trigger	Stand

As you release the mixer-release trigger, the top of the top of the trigger should clamp around the metal pivot.

For models equipped with a head-lock feature–To lower the mixer-head for normal operation, support the mixer head with one hand. Then press in on the head-lock latch. Gently lower the mixer head until the mixer head is in a normal operating position.

Latched Opening

Mixer-Release

Trigger

Be sure the mixer head is securely attached to the stand before using.

NOTE: This mixer is NOT intended for use away from the stand.

ADDING THE MIXING BOWL

Place the desired mixing bowl onto the turntable so that the groove in the bottom of the bowl fits into the correct groove in the turntable.

Mixing bowls should NEVER be used in a conventional oven, microwave oven, on top of the range, or on any other heated surface.

NOTE: If mixing bowls are scratched or chipped, do not use mixer. Mixer bowl should not be used to blend in hot liquids.

4