Sunbeam 2358, 2356, 2360, 2359 instruction manual Attaching the Beaters, Attaching the Dough Hooks

Attaching the Beaters

Be sure the Mix-Finder®dial is in the ZERO position and unplug electric cord from the electrical outlet.

Lift mixer head up and back to pull it out of the way of the bowl, while holding in an upright position.

NOTE: It is important that the beaters go into the correct sockets. Otherwise the mixer will not give you the proper mixing action. Do not risk ruining a recipe or damaging your mixer. Read the following instructions carefully.

One of the beaters is conical in shape and has a nylon button on the bottom. It goes into the socket on the side of the mixer nearest the side of the bowl. The other beater is square-shaped and goes into the socket nearest the center of the bowl. See beater symbols located on the front of the mixer head.

Square

Beater

Conical-Shaped

Beater

Nylon

Button

Side of

Bowl

Conical Square

Beater Beater

Insert the beaters, one at a time, using a combination pressing and twisting motion, until the beaters snap into position.

If a beater should not properly snap into place, pull it out of the socket and rotate it one quarter turn. Reinsert the beater into the socket until it snaps into position.

Attaching the Dough Hooks

Set the Mix-Finder®dial in the OFF position and unplug the electric cord from the electrical outlet.

Lift mixer head up and back to tilt it out of the way of the bowl, while holding in an upright position.

NOTE: The dough hooks must go into the correct sockets. The mixer will operate with the dough hooks in the wrong position. However, you will not get proper kneading action and you could risk ruining a recipe or damaging your mixer. Read the following instructions carefully.

5