APPENDIX
Thermal Printer UTP-58E
For general operation notice, see Thermal printer
UTP-58E for RC-8800S/D-B (Rack Console) and PP-8800A (Printer)
Push the upper part of POWER switch and the READY lamp goes on. If the READY lamp does not light, set a roll paper as shown below. When the lamp is on, data received from the radiotelephone is printed. After completion of printing, feed paper out by pressing the FEED button.
PAPER COVER
OPEN button READY lamp FEED button
READY FEED
POWER switch
ON
OFF
Paper replacement
1.Push the PAPER COVER OPEN button to open the paper cover.
2.Load the roll paper as shown below.
3.Set the roll paper so that the end of paper is outside the printer, and then close the cover by pressing both sides of the top of the paper cover.
1
2
3 3
