4. BASIC SETUP
4.6Position Setup
This is where you enter your position, automatically or manually.
1.Press the MENU key at the standby display.
2.Rotate the CH knob (or press up / down arrow key) to choose POSITION from the second page of the main menu.
**** SETUP MENU ****
T POSITION
PRINT OUT
VOLUME
SYSTEM
3. Press the ENT key. The following menu appears.
INPUT TYPE: AUTO
LAT :
LON :
TIME :
4.INPUT TYPE is selected; press the ENT key. The following setting window appears.
AUTO
MANUAL
Note: If the position data from a positioning sensor is available, MANUAL can not be chosen, i.e. the above window does not open.
5.Rotate the CH knob (or press up / down arrow key) to choose AUTO or MANUAL as appropriate and press the ENT key.
If you chose AUTO, your ship's position and time appear; press the CANCEL to close the menu and return to the standby display. These data are supplied from the navigation equipment connected.
Note: •If correct position data is entered from a position source during the setting of MANUAL, the setting changes automatically to AUTO from
MANUAL.
•If the message "GPS ERR" appears after you change INPUT TYPE from MANUAL to AUTO, confirm that the navigation device is functioning.
If you chose MANUAL, enter your position and time as follows.
6.Enter latitude (in four digits) with the numeric keys. If necessary, switch coordinates: 1 key to switch to North; 2 key to switch to South.
7.Press the ENT key and enter longitude (in five digits) with the numeric keys. If necessary, switch coordinates: 1 key to switch to East; 2 key to switch to West.
8.Press the ENT key and enter UTC time with the numeric keys.
9.Press the ENT key and CANCEL key to finish.
