TANDBERG 6000 MXP user manual

Appendices

The following page will now be displayed:

Figure 3

5.Enter the release key for the system to be upgraded in the ‘Release Key’ field. If no release key is given, the Far End System will use the previously stored release key if possible. This will work when upgrading from a main release to a dot release.

6 Make sure the setting “Far End System Upgrade” is set to “On” at the remote site. This setting can be found in the Settings/General/Permissions menu.

7.Enter the password set at the far end for remote upgrade (default password is “TANDBERG”)

8.Press ‘Install Software' .The system will now use about 90% of the call capacity to transfer the software file across. During this time, audio and video will be turned off.

9.Once the software has been transferred and verified at the far end, you will get a new webpage with information that the upgrade of the far end was successful. At the same time, a message box will appear at the remote system asking if you want to reboot the system to activate the new software.

10.To activate the new software. The ISDN connection needs to be closed, and the TANDBERG MXP system must be rebooted.

297