TANDBERG 6000 MXP Screen Settings, Software Options, Date and Time Settings, Save changes

TANDBERG 6000 MXP

Leave these settings unchanged if no special needs are required. See chapter General Settings for more information.

5. Screen Settings

When using wide screen (16:9) monitors, set VGA Monitor Format to Wide (16:9). TANDBERG also recommends the following settings:

ƒPicture Layout to Picture outside Picture as this mode provides a display layout optimized for wide screen monitors.

ƒAuto Layout to "On". The display layout may be changed at any time using the layout button on the remote control.

ƒUse screen as local PC monitor to "On".

ƒPC Picture Format to "Wide" (depends on your PC's VGA output).

6.Software Options

This menu item will display the currently installed options (such as MultiSite, Presenter and high bandwidth options). To activate any purchased software option for the system, an option key must be obtained and then entered into the Software Options menu (see paperwork accompanying the system for option keys). The MultiSite and Presenter option keys should be entered under “New Option Key”. Any bandwidth option keys should be entered under “New Bandwidth Key”. You may need to restart the system for options to take effect. For more information on these options, please contact your TANDBERG representative.

7. Date and Time Settings

Select your preferred Date and Time Settings.

8. Save changes

Remember to select the on-screen Save icon on the bottom of each menu (highlight using arrows and use the OK button to select) to save the changes you may have made.

Network configuration:

1. Open the Network menu

Press OK/Menu to open the Menu, if not already displayed. Select Control Panel - Network to open the Network menu.

2. ISDN configuration

Set the Network type to the desired network. Specify the settings for the selected network in the relevant menu. Enabled but unused ISDN lines (i.e. lines not active) should be disabled. For details, follow the instructions in ISDN /External/Leased E1/T1. See also the examples in Appendix 9: Connecting the system to the Switched

18