DefaultValuesSet
Dial
TANDBERG MPS API
User Guide
*r/end
OK
Command used to reset configurations to default values.
Parameters:
•Level: <1..3> Configurations are divided into three different storage classes. The level parameter denotes that configurations on this level and all levels below are to be reset.
OK Result parameters:
None
ERROR Result parameters:
•Cause: <1…> Cause code specifying why the command was not accepted by the system
•Description Textual description of the cause code.
Example:
xcommand defaultvaluesset level:2
*r Result (status=OK): *r/end
OK
Command used to initiate an outgoing call.
Parameters:
•Conference(r): <1..35>
•Number: <S: 0, 60> Number to dial.
•SecondNumber: <S: 0, 60> 2Xh221 second number
•SubAddress: <S: 0, 60> Sub address
•CallRate:
<1xh221/2xh221/64/128/192/256/320/384/H0/512/768/1152/1472/15 36/1920/Tlph> Specifies the callrate to use
•Restrict: <On/Off>
•NetProfile: <1..7>
•NetworkId: <1..32>
•NetworkModule: <1..12>
•DTMFSend: <S: 0, 32>
OK Result parameters:
•CallRef: <1..96> Reference to the call. To be used as reference when monitoring the call.
•LogTag: <1…> Unique reference to call. Identifies the call in the call log.
ERROR Result parameters:
•Cause: <1…> Cause code specifying why the call was not accepted by the system
•Description Textual description of the cause code.
Example:
xcommand dial number:666 callrate:256 netprofile:3
*r Result (status=OK): CallRef: 26 LogTag: 312
*r/end
54
