TANDBERG MPS API

User Guide

<configuration-type root command> <address expr> ?/help

Example 2.7

User wants to configure IP: xconfiguration ip ?

*h xConfiguration IP Assignment: <DHCP/Static>

*h xConfiguration IP Address: <IPAddr>

*h xConfiguration IP SubnetMask: <IPAddr>

*h xConfiguration IP Gateway: <IPAddr>

NOTE! Only typing xconfiguration ?, actually addresses all configuration elements within the xconfiguration root command. One would therefore expect that help on all configurations would be returned. But as described above, this is a special case and only listings of the top level elements are returned. To get help on all configurations supported by the system, type:

xconfiguration // ?

or

xconfiguration ??

2.3.2 Configuration read

To read configurations, type the configuration-type root command followed by an address expression:

<configuration-type root command> <address expr>

Example 2.8

User wants to read IP configurations: xconfiguration ip

*c xConfiguration IP Assignment: Static

*c xConfiguration IP Address: "10.47.8.20"

*c xConfiguration IP SubnetMask: "255.255.248.0"

*c xConfiguration IP Gateway: "10.47.8.1"

OK

2.3.3 Configuration set (write)

To set configurations, the address expression following the configuration-type root command must end with a colon. The value to be set must be added after the colon:

<configuration-type root command> <address expr>: value

24

Page 26
Image 26
TANDBERG D13639 manual Configuration read, Configuration set write, Xconfiguration // ? Xconfiguration ??